PDA

View Full Version : BIKE SERVICE


"Jackass"
09-20-2006, 02:42 PM
HAS ANYONE TAKEN THEIR RIDE TO BANKSTON'S IN DAYTONA? I'VE HAD REALLY BAD LUCK W\JIM WALKERS & FUN MACHINES BOTH. LOOKING FOR A SHOP THAT KNOWS WHAT THEY'RE DOING & THAT I CAN TRUST

mike
09-20-2006, 11:57 PM
Call Jim in the Parts Dept. at Deland Motorsports. He is a member on this board and a good guy. Don't tell him I said that. He will steer you in the right direction and help if he can. He may even post up if he's browsing the board.

I really can't comment on Bankstons or any other. Having a bike serviced and keeping it clean are overrated.....just kidding guys...but dirt does make you faster.

DaveInDaytona
09-21-2006, 05:20 PM
What do you need done and what kind of bike ?

CKER
09-21-2006, 07:01 PM
might not be the right thread to ask this, but i recently had a chain replaced, and since i got it back, it just dosen't seem to accelerate like it did before that, went from gold to silver, same size sprockets, and the adjusters were moved in a lot more, is there a weight difference between gold and silver, and if so does rotational mass make that much of a diffeence for a chain?

"Jackass"
09-22-2006, 05:37 PM
JUST SO YOU GUYS KNOW, BANKSTON'S DID ME RIGHT THIS MORNING WITH THE REPAIRS I WAS NEEDING. THEY'LL WORK ON ANY MAKE/MODEL SPORTBIKE AND TREAT YOU RIGHT.

coldduc
09-25-2006, 12:16 PM
might not be the right thread to ask this, but i recently had a chain replaced, and since i got it back, it just dosen't seem to accelerate like it did before that, went from gold to silver, same size sprockets, and the adjusters were moved in a lot more, is there a weight difference between gold and silver, and if so does rotational mass make that much of a diffeence for a chain?

plating on the chain won't make any difference.
have you verified same size sprockets front & back?
check for rear wheel drag, while bike is on a swingarm stand. if it doesn't rotate freely, start looking for why
rear axle over torqued, rear brake drag, missing spacers, etc
or bring it by & we'll look inspect it for you & advise needs F.O.C.
tony

DaveInDaytona
09-25-2006, 05:44 PM
That's where I was going with this.

Tony will take care of you on just about anything. He's kind of funny looking, but he knows bikes.

coldduc
09-25-2006, 05:49 PM
That's where I was going with this.

Tony will take care of you on just about anything. He's kind of funny looking, but he knows bikes.

:shock:
Dave,
I am sooooooooo hurt!
I won't stay away from the cheap shots with you anymore buddy boy...... :wink:
tony

CKER
09-25-2006, 06:07 PM
thanks guys much appreciated, will be by tomorrow, just need to know where you are located.


Thanks,

Rod

DaveInDaytona
09-25-2006, 08:16 PM
http://pcsdaytona.com/

http://pcsdaytona.com/images/pcsmap2.gif